Opening Hours: 8:00AM – 5:00PM

Knife & Flatware Pull Testing Device

This simple piece of equipment comprises of a slotted weight and beam and a knife-edge pivot point:

The knife edged pivot point has three positions for the weight marked with the nominal value of the resulting torque. The knife handle is gripped in a toggle clamp with rubber-lined jaws to protect the handle surfaces.

When the blade is placed in the horizontal slot of the beam, it is rotated by turning at its handle about the fulcrum until the end of the beam is raised from the bench, then the calculated torque is applied to the joint of handle and blade. The weight attached to the lever can be slotted in to any one of three positions to produce one of three torques i.e.

  • 4.5 Nm for handles of an area of 37 cm² or more (most handles)
  • 3.7 Nm for handles of an area below 37 cm² (most knives)
  • 2.2 Nm for non-metal handles (knives within the scope of table cutlery standard BS 5577, but not EN 8442-2)

This device is also used for Kitchen Knife Bend Strength Testing.

Suitable for Attachment of Handles to

EN 8442-1: Clause 6.3

EN 8442-2: Clause 7.3

Contact Us for more information on our Handle Twist Tester

Loading...